The most important factor in getting any finish to properly bond to any exterior wood is to not let it be exposed to uv prior to finish enough damage to compromise the final coating can be done in as little as 1 week depending on exposure.
How to stain board and batten siding.
In this case it is best to forgo the paint and use an exterior stain or sealer instead.
Board and batten siding.
You should use siding nails to put the battens in place and you will need three and a half inch ones if you can get them.
Here are four methods to do the job right.
Battens which he says he ll finish with a high quality stain.
Apply chemical stripper to the siding.
His plans call for 9 1 2 in.
Allow to sit until the stain begins to lift and bubble.
While traditional board and batten siding uses wide boards and narrow overlying battens there are variations of the traditional narrow over wide technique.
The nails have to go an inch and a quarter to an inch and a half into the furring strips or.
Use a wide paintbrush to apply the stripper to a 2 to 3 foot wide area of the siding.
Check the type of wood if you are painting the siding for the first time on the side of the building.
You should get the primer or stain tinted to match the paint colour you have chosen.
Board and batten siding recently installed on our boathouse using cedar boards stained with cabot solid color acrylic deck stain in dark slate.
Writing to fine homebuilding s breaktime forum wenws is looking for some advice on the best way to finish the board and batten siding for his new house.