Depending on the make and model there is a different method to adjust the tension.
How to tighten awning over slide out.
Since you do not tell me who manufactured your slideout topper awnings it will be very hard for me to tell you how to adjust the tension on them.
In order to get the awning up and stable the tension needs to be adjusted to get the fabric taut.
You ll be sitting cool in the shade.
The roller has a spring in it.
How to replace spring on awning slideout in rv adjust slide out cover how to tighten loose motorhome slideout covers tightening the spring on a slide out awning slide out kover ii how to adjust spring slide awning toppers tension adjustment how to tighten a carefree slideout topper how tochange the tension on a carefree of colorado.
Different rv makers use different awning systems.
Step 5 re install awning.
Many if not most slide toppers have only one spring which is probably the side that is tight.
Two people will handle the awning arms one at each end while another one will feed the cord into your awning rail.
And i ve called and left a message still awaiting the return.
Run slide in about 12.
Roll the awning back up to observe how tight it is.
Adjusting slide topper awnings is fairly simple.
I had my slide out awnings installed by the dealer lakeshore rv.
Just like that your awning is back in action.
If you are satisfied move on.
Remove end cap or mount.
Dear jim well it depends on the size and make of your slide topper.
It s best to have three people for this job.
However perhaps someone here knows how to tighten the slide out awning.
Look for the pin hole near end of roller.
During regular use of your rv the awning fabric and slide in the awning tube causing alignment is.
The awning over my slideout is sagging on one end but the other end is tight as both ends should be.
If you over tighten the spring it will break.
Thanks for submitting your question on our ask an rv question page.
Roll up topper on roller.
Is there a way to adjust the tension on the end of the awning.
The slight slack allows water to puddle then as the puddle gets bigger.
Here is brad taylor showing how to adjust an awning fabric.
If not then repeat the previous steps.
The last step is to reinstall the rv awning.
Roller should now be free of mounting hardware.
And rvs with slide outs a compartment that extends out from the main cabin providing extra living quarters are sometimes made with awnings over the slide out.
Only rotate the legs one or two turns at a time and don t do more than 4 or 5 total.
Make sure it will not fall out.
You do not need to put the screws back in.
Usually takes 2 people.
