How To Treat Wood Siding Next To Deck

Following this the wood needs to fully air dry.

How to treat wood siding next to deck.

It is this board that on every deck i have inspected is improperly installed flashed. Pry off as many of the intact sections as possible. While standing on the ground or on a ladder next to the deck use a claw hammer or pry bar to remove rotten wood deck boards. They may be great for boats that have teak wood and such but not so much for your deck.

Snap a chalk line cut out the siding and tack up the ledger board. Some options to treat untreated wood are wood oils top coatings sealers and stain sealant combo products. If your home has wood siding examine the siding around and beneath the windows for signs of swelling or discoloration. To do so start by cleaning the wood and drying up the remaining water.

Step 2 sand the entire surface of the wood along the grain with a sander and 250 grit sandpaper to make it smooth. At this point you can apply a fresh coat of oil or oil stain. After intact sections are removed turn the boards over and pound out the nails from the back. You don t need to use fans or tools to help aid in the process.

Wash the wood with soap and water and allow it to dry completely. Your oiled siding will look so good that you won t believe you did it yourself. Then slip flashing behind the siding covering the top edge of the ledger. Start by making an outline on the siding where you want to position the ledger board.

Paint can hide wood rot so poke the siding with the tip of the. Ipe wood throws the excess oil right back at you. Hand sand corners edges and other areas difficult to reach with the sander. A light touch is all it needs.

Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides. If your house has siding that siding must be cut away and the area must be flashed properly before the ledger board is attached to the house. With an oiled surface clean the wood with a pressure washer apply a coat of wood bleach let it stand per the manufacturer s instructions and pressure wash again. Be sure to use safety glasses.

Don t use film forming coatings. There are different wood sealing options for outdoor use but the best choice is often related to the specific project. The easiest way how to treat untreated wood for outdoor use is to apply a wood sealer. For best results the stain should be applied within 48 hours of the bleach treatment.

You most certainly need to use penetrating oils to help the wood keep that dark color. But when applying the oils a light touch is what you need.